Chemical automatic lubricators type PERMA FUTURA
Automatic lubricators PERMA are based on principle of chemical reaction, when is the solid substance transformed to gas, which forces the lubricant out of lubricators.
The best is to place the lubricator directly to the thread of the lubrication point, or it is possible to place a short line between the lubricator output and the lubrication point (it is recommended the max. length 1 m, on condition d=10 mm the inner diameter of the tube).
The lubricator is pre-filled with universal grease or oil (wide range of lubricants by request).
By oil use it is recommended to install the check valve on the output of the lubricator (see the page accessories for automatic lubricators).
Reservoir is single-shot (refilling is not possible)._x000D_
Type PERMA FUTURA
Technical parameters:
- Reservoir capacity: 120 ml
- Lubricant: grease up to NLGI 2 or oil
- Temperature range: 0 °C to +40 °C
- Time of emptying: determinated by used activation screws: yellow – 1 month, green – 3 months, red – 6 months, grey - 12 months *)
- Max. pressure: 4 bar
- Material: steel, plastic
- Output thread: R 1/4"(a)
*) ATTENTION, the higher/lower temperature of the surrounding the shorter/longer time of lubricator emptying. The given values are valid for PERMA CLASSIC for surrounding temperature +20 °C.
For other accessories see the general chapter Accessories for automatic lubricators with output thread R 1/4"(a).
Product filtering
Number of products found: 56
Perma Futura SF 01, type 01
Perma Futura SF 01, type 03
Perma Futura SF 02, type 01
Perma Futura SF 02, type 03
Perma Futura SF 02, type 06
Perma Futura SF 03, type 01
Perma Futura SF 03, type 03
Perma Futura SF 03, type 06
Perma Futura SF 03, type 12
The listed prices are without VAT and apply to the quantity that is currently in stock
Show on page
- 10
- 50
- 100
- 1
- 2
- …
- 6
- Next
Load 10 more
